Product Overview
The ESP8266 started a small revolution by bringing WiFi to a small and cheap package that also had enough processing power and enough pins to get small things done. Now get ready to take your bite-sized WiFi capabilities to the next level with the ESP32 Development Board!
Firmware tips:
- Connect the micro USB directly from the computer to the board. Do not use a hub in the middle. Use a short cable.
- Install the ESP32 Arduino IDE addon (see video below).
- Select ESP-32 Dev Module in the Arduino IDE.
- Put the ESP32 into boot mode by holding down the BOOT button and pressing and releasing the EN button (reset).
- Select the serial port (if the serial port does no appear, ensure that the CP2102 drivers are correctly installed).
- Start the download process. When the download starts, press and release the BOOT button again. The download process should now start.
- The community at http://esp32.net/ has the best support and information regarding the ESP32.
Specifications
- ESP-32 Module: ESP-WROOM-32 (ESP32-D0WDQ6 dual core)
- Antenna: Onboard
- Board size: 51 x 30 mm
- Micro USB
