Product Overview
This low cost starter kit focuses on providing many different discrete electronic components. The microcontroller included is a generic Arduino MEGA 2560 Rev 3. Please note that there are no instructions for this kit. BATTERIES NOT INCLUDED.
This kit includes:
| Item | Quantity | Description |
| 1 | 1 | Mega2560 R3 development board |
| 2 | 1 | USB cable |
| 3 | 1 | Prototype extension board |
| 4 | 1 | Mini breadboard |
| 5 | 1 | 5V stepper motor |
| 6 | 1 | 2003 stepper motor driver board |
| 7 | 10 | Red LED |
| 8 | 10 | Green LED |
| 9 | 10 | Blue LED |
| 10 | 2 | Vibration Sensor |
| 11 | 1 | Flame sensor |
| 12 | 1 | LM35 temperature sensor |
| 13 | 1 | Infrared receiver |
| 14 | 3 | Photoresistor |
| 15 | 4 | Key cap |
| 16 | 4 | Key button |
| 17 | 1 | Adjustable potentiometer |
| 18 | 1 | Passive buzzer (piezo buzzer) |
| 19 | 1 | Active buzzer (tone generator) |
| 20 | 4 | Jumper cap |
| 21 | 1 | Large breadboard |
| 22 | 1 | Remote Control |
| 23 | 1 | 1602 LCD Display |
| 24 | 1 | SG90 servo |
| 25 | 1 | Component box |
| 26 | 20 | Female to Female jumper wire |
| 27 | 30 | Breadboard line (approximately) |
| 28 | 1 | 8 * 8 dot matrix |
| 29 | 1 | One digit eight segment display |
| 30 | 1 | Four digit eight segment display |
| 31 | 1 | IC 74HC595 |
| 32 | 1 | Battery Holder |
| 33 | 40 | 2.54mm pin header |
| 34 | 10 | 220 Ohm resistor |
| 35 | 10 | 330 Ohm resistor |
| 36 | 10 | 1 kOhm resistor |
| 37 | 10 | 10 kOhm resistor |
